1-877-Poolhub/877-766-5482 for Help

Customer Service Policy Details Privacy Policy Pool Tips Testimonials
         
        View Cart Site Map
 
Sort By Manufacturer
Your Navigation: Home> Pool Tips    

     

Browse By Product Catalog
   
* Aboveground Cleaners
* Aboveground Filters
* Aboveground Heaters
* Aboveground Pool Liners
* Aboveground Pumps
* Aboveground Systems
* Alternative Sanitizers
* Automatic Pool Cleaners
* Chemical Products
* Chlorine Generators
* Pond Products
* Pool Controllers
* Pool Filters
* Pool Lighting
* Pool Heaters (Gas)
* Pool Heat Pumps
* Pool Pumps
* Pool Toys
* Replacment Filters
* Replacement Motors
* Solar Blankets and Reels
* Solar Heating
* Submersible Pumps
* Valves & Plumbing
* Wintercovers

Special Pool Needs
   
* Pool Parts Request
* Pool Consultations
* Content Library
 
For Pool Pumps    

*Oversizing or undersizing pumps in relation to pool and plumbing sizes will result in less than optimal filtering efficiency.

*Pumps should be elevated 4-6 inches from ground level to extend motor life.

*Regularly clear debris from pump and filter areas to promote motor cooling and extend operating life.

*Install motor cover to protect from extreme weather.

 
For Pool Filters    

*Oversizing cartridge filters will enhance filtration efficiency.

*Oversizing or undersizing D.E. or Sand filters will result in less efficient filtration.

 
For Pool Heat Pumps    

*Heat pumps are the most efficient method to maintain pool water temperatures…35-45% of the cost of natural gas and less than 30% of the cost of propane gas. (depending on geographic location)

*Your owner’s manual will specify proper installation steps and placement distances.

 
For Pool Cleaners    

*Electronic controlled and pressure cleaners are best utilized in heavy debris areas.

*Suction side cleaners with Arneson Debris Canisters added help prevent suction pipe and pump clogging.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
   
For Heaters 
1. Check your pool chemistry regularly to maintain top operating 
condition.
2. Use a pool cover or thermal blanket on your pool when it’s not in 
use. Evaporation accounts for 70% of heat loss from your pool.
3. Add wind breaks to your pool. A 7-mph wind at the surface of a pool 
can increase energy consumption  300%!
 
Inground Pool Gas Heaters—Recommended sizing--BTU’s
         
Pool surface area:  Sq.Ft Minimum Size BTU output (000’s):      
900 400      
700 350      
500 250      
300 200      
         
Spa Gas Heating Effectiveness Examples      
Heater BTU output (000’s): 150 250 350 400
         
Spa size (gals.) Time (mins.) to increase water temperature 30 degrees:
400 50 30 21 19
600 75 45 32 28
800 100 60 43 37
1000 125 75 54 47
         

*Over sizing your heater will mean quicker warm ups, greater efficiency and energy savings.

*Your owner’s manual will specify proper installation steps and safe placement distances from buildings, windows, etc.

Note: All indoor heater installations must include an indoor adaptor kit to vent the heater outside of the enclosure.  Propane gas heaters installed outdoors should have a High Wind Stack to prevent the pilot-light from blowing out.